Manual duplicate (set copy) for WORM enabled LSU does not show the settings to define the retention values for target LSU
Article ID: 100054710
Updated On:
Description
Error Message
No error information presented
Cause
This issue is currently under Investigation.
The Manual Duplicate Job does not show retention lock settings:
Duplicate Stage as part of Backup Job has retention lock settings:
Resolution
There are no plans to address this issue by way of a patch or hotfix in earlier versions of the software at the present time. However, the issue has been addressed in the revision of the product specified at the end of this article.
Please contact your Veritas Sales representative or the Veritas Sales group for upgrade information including upgrade eligibility to the release containing the resolution for this issue.
This issue is resolved in Backup Exec 22.1.
Workaround :
It is recommended (for now) to duplicate the backup set to WORM enabled LSU as part of the Backup Job Definition.
Issue/Introduction
Additional Information
