Unable to configure DNS when doing recovery using Simplified Recovery Disk
Article ID: 100050993
Updated On:
Description
Error Message
Unable to configure DNS when doing a recovery using the Simplified Recovery Disk. The following error is seen:
Could not enable DNS. Unable to notify DNS service.
Resolution
1. Press "Cancel" in "Network Adapter Configuration" screen.
2. Click [Analyze] [Open Command Shell Window].
3. Run a command "net start DNS Client".
4. After the command completes, configure DNS IP addresses in "Network Adapter Configuration" screen again.
Issue/Introduction
Unable to configure DNS when doing recovery using Simplified Recovery Disk
Additional Information
ETrack: 4040041
Was this article helpful?
Yes
No
Powered by
