"Could not enable DNS" error appears when configuring DNS server addresses on System Recovery Disk that is created by Windows 10 (version 2004) or ADK 10 (version 2004).
Article ID: 100048314
Updated On:
Description
Error Message
Could not enable DNS. Unable to notify DNS service.
Figure 1
Cause
DNS client does not start.
Resolution
This issue has been resolved on System Recovery 21.3.
Workaround:
1. Press "Cancel" in "Network Adapter Configuration" screen.
2. Click [Analyze] [Open Command Shell Window].
3. Run a command "net start DNS Client".
4. After the command completes, configure DNS IP addresses in "Network Adapter Configuration" screen again.
Issue/Introduction
"Could not enable DNS" error appears when configuring DNS server addresses on System Recovery Disk that is created by Windows 10 (version 2004) or ADK 10 (version 2004). Unable to configure DNS.
Additional Information
ETrack: 4012508
Was this article helpful?
Yes
No
Powered by
