If you run the VerifyImage PowerShell script in Veritas System Recovery 18 SP1, while any backup/restore/physical to virtual conversion job are active, Veritas System Recovery displays the “The remote procedure call failed” error.
Article ID: 100043404
Updated On:
Description
Error Message
Resolution
Run the VerifyImage PowerShell script when no backup/restore/physical to virtual conversion job is in progress in the Veritas System Recovery console.
Issue/Introduction
Veritas System Recovery displays the “The remote procedure call failed” error if you run the VerifyImage PowerShell script in Veritas System Recovery 18 SP1, while any backup/restore/physical to virtual conversion job are active.
This issue is seen only when both VerifyImage PowerShell script and backup/restore/physical to virtual conversion job are running simultaneously.
Was this article helpful?
Yes
No
Powered by
