To connect to the iSCSI target devices during SDR, open a command prompt, and run the following commands in the order listed:

Note: Before performing the following commands, make sure that Networking Service is started and then IP address is assigned.

1. Click the Utilities tab and then select Start Command Prompt. (Figure 1)
   
   Figure 1
   
    
2. Type the following commands:

• net start msiscsi
• iscsicli QAddTargetPortal
• iscsicli ListTargets
• iscsicli QloginTarget
  
  Replace with the iqn of the iSCSI target.