How to edit the System Recovery client installation packages in System Recovery Management Solution so that client computers do not automatically reboot after the install.
Article ID: 100001159
Updated On:
Resolution
1. Go to the Packages and Policies tab
2, Expand Update Packages in the column on the left
3. Select the BESR installation package to edit (either Install With User Interface Package or Install Without User Interface Package)
4. Click on the Programs tab on the installation package
5. Select English (or the desired install language to edit) from the drop-down box
6. In the Command line field change
REBOOT=Force to: REBOOT=ReallySuppress Note: If the REBOOT switch does not exist. Instead, the /BOOT switch must be removed.
7. In the After running drop-down box change the setting to No action required
8. Click Save changes
9. Click Update Distribution Points
7. In the After running drop-down box change the setting to No action required
8. Click Save changes
9. Click Update Distribution Points
When clicking on 'Install Veritas System Recovery [Version]', ensure that the relevant language (as per step 5 above) is selected from the 'Program name' dropdown list, then enable and save the agent policy.
When new computers are selected under Install Policies to apply this installation package, the client computers will not be automatically rebooted. However, these computers will still need to be manually rebooted at a convenient time to complete the SR installation prior to assigning and running a backup job.
Issue/Introduction
How to edit the System Recovery (SR) client installation packages in System Recovery Management Solution (SR-MS) so that client computers do not automatically reboot after the install.
Was this article helpful?
Yes
No
Powered by
